Jump to content

Archived

This topic is now archived and is closed to further replies.

nrcapes

737 NG radio stack inop. Help for a newb!

Recommended Posts

I have only had the PMDG 737 NG software for a day and am going through the Metzinger Advanced Tutorial. I can't set the com or nav radios from the radio panel that comes up when I press R on the 2D main panel. The transponder sets fine, but the ADF can't be set either. I am going crazy with this!Is there any solution? I was able to set the radios on the first flight but never since.

Share this post


Link to post
Share on other sites
I have only had the PMDG 737 NG software for a day and am going through the Metzinger Advanced Tutorial. I can't set the com or nav radios from the radio panel that comes up when I press R on the 2D main panel. The transponder sets fine, but the ADF can't be set either. I am going crazy with this!Is there any solution? I was able to set the radios on the first flight but never since.
Nameless (You should use your full real name as per forum rules),Load the default cessna first and set it up so that the radio panel is on, battery is on and engine off. That solved the described problem at least in my case.BestHolger Kneib

Share this post


Link to post
Share on other sites

I'm not sure why you are seeng "nameless." My post clearly shows my name of nrcapes. I don't see any way to change a profile, either.This solution did not work. The radio problem happens randomly during flight. The only way I have been able to solve it is to re-install the PMDG aircraft.

Nameless (You should use your full real name as per forum rules),Load the default cessna first and set it up so that the radio panel is on, battery is on and engine off. That solved the described problem at least in my case.BestHolger Kneib

Share this post


Link to post
Share on other sites

Your full name, not forum user name, is required. To add a signature to your AVSIM posts click the down arrow next to your name and select My Profile. In the Upper Right click the Edit My Profile button. When the profile page opens on the left select Change My Signature or whatever tab and enter your name and whatever else you might think is appropriate to add to the end of your current and new posts. Then save all of your changes.

I'm not sure why you are seeng "nameless." My post clearly shows my name of nrcapes. I don't see any way to change a profile, either.----------------snip-------------------

Share this post


Link to post
Share on other sites

×
×
  • Create New...