I am trying to install the MD11 FS9 Combo pack without much success. I have tried to install it two ways. First just clicking on the exe within the Total Commander but had a disability message. See attached screen shot. Then I tried to open the file in a Temporary file, then clicked on the exe again. Unfortunately, the results were again the same. It keeps referening back to the FS9's location.Could someone throw some light on this for me please?Best regards.

Get the free Registry Repair tool from Flight1. It will allow you to easily check the registry and correct the info there.http://www.flight1.com/view.asp?page=libraryHope that helps.

Thank you very much. Will try.Best regards.

Hello,It's also possible that this MD-11 PMDG installer is searching for the FS9.EXE updated (patched)Regards.Gus.

I don't know Gus, I only have one FS9.:(

I have downloaded the Registry Repair Tool, tried to install the Beasty, but now it was asking for the FS9.1 update. Unfortunatelly, due to all the extra add-ons like a/c, airports IVAO and VATSIM files, I have to de-install and re-install my FS9 and hopefully I shall be operational in a few hours time.:(

G'day All,I am back again. I have re-installed a clean FS9 (no add-ons) I have also installed into the FS9!!!! the FS9.1 update. After this, I tried to install the PMDG MD11 aircraft, but will not install. Actually, it says I only have an FS9 installation, have to install FS9.1 or higher. When I try to install the FS9.1 update the message I have, I don't need to as I already have one installed.I am also providing two screen shots to make myself clearer.Thanks and regards.

G'day All,I am back again. I have re-installed a clean FS9 (no add-ons) I have also installed into the FS9!!!! the FS9.1 update. After this, I tried to install the PMDG MD11 aircraft, but will not install. Actually, it says I only have an FS9 installation, have to install FS9.1 or higher. When I try to install the FS9.1 update the message I have, I don't need to as I already have one installed.I am also providing two screen shots to make myself clearer.Thanks and regards.

Much will depend upon how you uninstalled FS2004 - if you only used the default uninstall routine and did not manually delete the various files and folders which it leaves behind, then your new install is not a "clean" install.If you follow the suggestions in this file you should get better results:http://library.avsim.net/esearch.php?CatID=fs2004misc&DLID=123907Hope that helps.

Check your PM's (Personal Messages)