HiI recently purchased CLS Sydney for FSX, only to find the jetways are static objects. I have tried editing it in AFX, adding default jetways, but then I go into FS and the jetways i added don't appear.Does anyone know a way around this?

Please reply

I don't run that scenery, but I think it will exclude the default objects by design. So you would have to remove the exclusion definitions in the bgl file to get the jetways to show up. Just guesswork though.

thankyou i will try that

I don't have the scenery, but there might be an AFCAD file with the scenery that you could edit using an AFCAD editor.

They are talking about a version with default FSX jetways here. Maybe you can ask the folks, if you haven't already. http://www.commercia...358

They are talking about a version with default FSX jetways here. Maybe you can ask the folks, if you haven't already. http://www.commercia...358

thanks i put a post there, it is waiting for approval by moderators

thanks i put a post there, it is waiting for approval by moderators

anyone have any idea how long it takes for a post on CLS forums to be approved? my post is still not there

They are talking about a version with default FSX jetways here. Maybe you can ask the folks, if you haven't already. http://www.commercia...358

i have been told a version should have been included with the default fsx jetways. Anyone know why it wouldnt be?

Sounds like another support issue. I don't run that scenery so I couldn't tell, but maybe you can write them your order details to get a clarification and maybe the additional version.

turns out there was no version with default jetways :(why would they say that there is when there isnt?