I installed last week a new console with 6 more modules including the TQ6, in addition to my previous setup.Since then, I lost my slew command, or to be more accurate, I can select slew mode but my plane starts spinning madly in a large circle and I cannot stop it. In other words, I cannot use the slew command anymore.Any clue as to what I can do to rectify this? For info, I tried to re allocate the slew key to different keys without success, problem remains the same.Thank you for any assistance!

Sounds like one of your new modules must be sending a constant command (sticky key?) to the simulator that the sim is interpreting as a slew movement command.

The cowboy is probably right, but you could try disabling the new modules or if it's a joystick that's doing it, you could disable the joystick, slew, and then re-enable it.

Thanks for your guidance. After disabling my modules one by one, I could isolate the one which caused the problem (TQ6) and found the way to avoid my slew problem by changing one line in the device cfg.Many thanks again and happy landings!