July 11, 201213 yr Finally replacing old CH Pedals with gameport interface but run through a gameport to USB converter. Can't have toe brakes on that setup. Plugged in a new USB set of CH pedals and used Control Manager 4.52. The program recognizes the pedals in the screen where you select the yoke or the pedals. So I went to calibration after selecting the pedals. There the calibration screen shows no change when moving the pedals nor does anything show in the axis numbers on the right side. I tried the Map thing but no luck there either after assigning the remaining axis V to pedals. Even tried Slider 0 & 1.. Sort of dumbfounded... CH Yoke Pedals, Windows7 64bit regards, Dick near Pittsburgh, USA
July 11, 201213 yr Try to disconnect and reconnect or swap to a different port. Is there a chance that you are using a USB 3.0 port? From what I've read and found, CH Controllers cannot use USB 3.0, only USB 2.0 and below. Philip Manhart :American Flag: - "Wise men talk because they have something to say; fools, because they have to say something." ~ Plato
July 11, 201213 yr Author Try to disconnect and reconnect or swap to a different port. Is there a chance that you are using a USB 3.0 port? From what I've read and found, CH Controllers cannot use USB 3.0, only USB 2.0 and below. You are absolutely correct. Used a 2.0 port and the pedals "magically" worked. Many thanks!! regards, Dick near Pittsburgh, USA
Create an account or sign in to comment