just installed matroxtriplehead2go digital, not impressed, graphics to large. All Ive read indicates the resolution should be 3x monitors.res. i am using 3- 22 inch monitors res 1920x1080, but only getting 3824x1024 res. seems like ishould get 5460 x something.? If this is the wronge forum I am sorry. Thanks.

 

 

 

windows 7-64.video card nvidia gtx470. MB i7 960,

I went through this same battle. Once I called TH2Go support and they walked me through some tweaks. Later I upgraded my machine and was back to the lower resolution. Finally sprung for the second 560Ti and SLI'd the two. The results were much easier to achieve and with the surround configuration, I was able to adjust for the bezels to make the three displays seemless. Works great now with FSX with the resolution I wanted. Good luck.

JME> Thanks for your reply, I have junked matrox and gone back to my 4 monitor cockpit, to much of a hassle. I will be 80 yrs in two weeks, so I doubt If I will ever see anything that is true plug and play. Thanks.

I think the issue may be that the TH2G seems to have four video modes that you can set up for use at any one time. Of course you can choose which ones. I believe the defaults start at 800x600 and go up to 3840x1024. At least it stops at 3840 on my machine with 3x1280x1024.

 

For the extra wide, I would look at replacing the 3840 mode, using the UI. I know, it shouldn't make you do this. But 3 monitors with bezel correction and a TrackIR is a great setup.

 

Don't give up too easily!

 

Rudder

 

Sorry, I may have been premature. The Matrox site has this to say about the higher resolutions:

 

"These widescreen modes are only available when TripleHead2Go Digital Edition is connected to the system's dual-link DVI output."

 

Your GTX 470 seems to fit the bill, so it is a mystery to me too.

Thanks for your re-ply. I have gone back to this project. have purchased three 22 inch LG. 1920x1080 monitors. have comp prob. man coming frid. still trying to figure out what duallink DVI is.