Hi there,

I have an issue with Bill ERJ panel, where I cannot start the APU nor the engines.

When I click on them, I can see the hand, but nothing happen I tried going around the area, but with no luck.

all other buttons are fine. I have the version 4.0.2.

Any idea how can solve this issue.

Thanks

Hello I will try to help you. I haven't used this panel for a long time now,It is more complex than normal.

First have you located the overhead panel?

Andy

 

Anyways try this or starters.

 

Open the overhead panel .On far left you will HYDRAULIC directly below 'electrical' sys1 and sys2 switch to auto.Go to FUEL section switch ON. Back left you will see APU GEN to the right is APU MASTER SWITCH TO START.

See what occurs ,that SHOULD be right.

Anyway enough to get you going for now.

If in doubt fiddle about , that's how I usually get going with more complex panels.

Cheers Andy

Lovely panel, visually on a par with the payware FeelThere version IMO (if less complex & realistic).

 

Andy's almost right. APU start sequence is...

 

1. Battery on (BATT 1 turn to AUTO)

2. Fuel pump 2 on (TANK 2 turn to ON)

3. APU start (APU MASTER click on ON)

 

Engine start is then...

 

1. Fuel pump 1 on (TANK 1 turn to ON)

2. Engine 1 start (START/STOP 1 click and hold on START)

3. Wait for engine 1 to stabilise

4. Engine 2 start (START/STOP 2 click and hold on START) - fuel pump 2 is already supplying the APU of course.

Good day gentleman's

I thank you so much for your help, it worked like a charm. I have trying for days to figure it out.

You are my savior.

Have a great day to all.

Best regards

Hani