September 22, 201213 yr I Have This warning at EICAS everthing is okay FMC is set Engines Running APU İs Off Packs on bleeds on apu power is off bleeds are on and takeoff data is set but ı have an warning named ENG NO TO Data what is that
September 22, 201213 yr It's shown when your takeoff data is no set. Just re-enter TO data on the overhead/MFD TO page as it may have reset.. If your still getting it then there is an issue with the install on the aircraft.
September 22, 201213 yr Author when ı press to config test button it says takeoff config okay that sign goes whe ni get full thrust at takeoff
September 22, 201213 yr You also need to "check your takeoff data", make sure the takeoff data is also saved. Tom "I just wanna tell you both: good luck. We're all counting on you."
October 9, 201213 yr Let me see if I can replicate the failure tonight. I will get back to you, if I don't reply to the thread by at lead tomorrow night please send me a PM to remind me. Second thought - http://www.youtube.com/watch?v=8mWzyr48mKs this totorial may be able to help you out as well. Tom "I just wanna tell you both: good luck. We're all counting on you."
October 11, 201213 yr ı solve this but now ı have DFDR Fail Im New At embraer Turn the beacon on, this will solve it. Tom "I just wanna tell you both: good luck. We're all counting on you."
January 14, 201313 yr when ı press to config test button it says takeoff config okaythat sign goes whe ni get full thrust at takeoff The takeoff config button has nothing to do with the TO DATA message. To config button just verifying that flaps are set, trim is set in the green, park brakes are off, and spoilers are not deployed. As stated above, DFDR is set to run when the beacon is on.
