I have just installed Linda 1.1.1 (with all relevant updates for FSUIPC etc.)

 

I have the full FSX suite installed in th C: root.

 

I am using Thrustmaster HOTAS X as J0 and Cyborg X as J1

 

On setting up the FSX default aircraft.in the Thrustmaster (which is intended as the primary joystick for flying operations, using the cyborg for secondary engine/navigation management), I have discovered the following:

 

LINDA bt. 1 (trigger) (Bt. 0 in FSUIPC - works fine

bt. 2 jumps to H1:0 on the guide (in FSUIPC jumps to bt. 32) (this was intended as a view button - and did work originally on first set up.

bt. 3 performs as bt. 5

bt. 5 shows no response

H1:1 jumps to bt.2

 

The other buttons on J0 appear to work fine and the hatswitch works fine on all pan positions.

 

My question is, is this LINDA being erratic or what?

 

Comments would be welcome.

 

 

Schaefer

I'm not sure what the problem is but make sure you have removed the Thrustmaster TARGET software and test again, perhaps it is interfering. Do the same for your other hardware too if it has any special assignment software. Reboot the PC then plug your joysticks into different USB port not used before, this sometimes forces drivers to be reinitialised which can clear some issues.