I am looking for a way, if there is one, to access the "calibration" between the joystick throttle and the cockpit throttle levers position.

 

Would like to be able to set minimum joystick throttle position to cause the cockpit throttles to go into "reverse pitch" mode.

 

Not sure if this is a gauge that can be tweaked or if it is hardcoded and this is just a pipe dream..... :(

 

Anyone know if this is possible ?? Anyone do it on the C90 ??

 

Thanks in advance ---- Bob

I could be wrong; however, I do believe that you can achieve this only through a registered copy of FSUIPC. There are many other advantages to having a registered copy of FSUIPC. I use mine to calibrate my throttle and other levers. I do not use it for setting the reverse zone as my Saitek tq has reverse zones already. I am sure I have seen a setting for reverse zones in the FSUIPC setup section.

I could be wrong; however, I do believe that you can achieve this only through a registered copy of FSUIPC. There are many other advantages to having a registered copy of FSUIPC. I use mine to calibrate my throttle and other levers. I do not use it for setting the reverse zone as my Saitek tq has reverse zones already. I am sure I have seen a setting for reverse zones in the FSUIPC setup section.

 

Hi Edward -- yes, it does have "reverse settings" BUT it is not at all clear what can, if anything, to get it to work. I did a couple of set up experiments, but the B200 control does not respond as you might expect. Not sure if it will work, but I am gonna look around a bit and see what I can find.

 

Thanks for your comments! --- Bob

It is possible to get revers thrust using FSUIPC with CH Products throttle quadrant. Guess I haven't looked at the throttles to see if they are physically imitating the the reverse positions. If thats the question. They do emulate the throttle reverse position precisely.