Already posted this on fsuipc support forum, but helps to ask here too.

 

I have a defualt set of controls setup in fsuipc for all FSX a/c

 

But unfortunatly PMDG seems to comply with very few of FSX controls, so i need to use fsuipc "aircraft specific"or profile for PMDG, so that when fsuipc sees the key combo's it would forward to FSX eventually getting to PMDG.

 

example ctrl+shift+e is typical of the key combos i am using

 

tried to use press&release, but can not figure out what the parameter to pass should be, should the parameter be the key combo, if so do i pass ascci, not sure format for passing something ctrl+shift+e

 

Generally which is the best way to solve this problem, (not using simconnect or widefs)

 

 

 

Cheers

• 
   
  

What exactly do you want to do with your key combo?

Hi

 

For standard key press combinations you can use the “Select for keypress” option on the left panel of the Buttons and Switches tab of the main FSUIPC control panel, this is the option I use for all the standard commands such as the TOGA and Gear Toggle commands.

 

If however you are using the SDK that was released for the NGX then that is a different matter and at the present time a bit above my experience level.

 

I hope it helps.

 

Jim Hodkinson

The profile management happens in the axis window. This is where you specify what the profile name is, which axes you are sending etc. This is NOT where you send the keys.

Rather use the other tab, I think it's called KEYS or BUTTONS, in which you can select if its profile connected or general, and there you can specify what key-combo is sent by which button, if general or profile only.