Is there  a way i can disable crash detection for simulating a gear failure without the simulator doing that thing where it hits the ground and jumps back to 1000ft? Currently i can slide the aircraft down the runway with a gear failure but once it comes to a stop CRASH shows on the screen and the sim resets the flight.

 

If i turn crash detection off, as soon as i hit the ground the plane jumps back to 1000ft AGL. 

 

I want to simulate crash landings and not have either of these occur, can it be done?

Only thing you can make is to modify some stances in the contact points related to the strenght of the gears on ground and also the time for gear deployment

So you will have to lower your gear as a normal landing .. and when touching the ground .. the gear will collapse and the aircraft will be on his belly and the sim will not reset !

Check the message I send to you as demo !