PMDG 737 NXG Problem

[jetsmell 45]

The problem  seems to be with some of the switches and buttons. On the auto pilot , the speed set gauge does not light up. The gauge that sets the vertical climb does not light up at first , but does after a few minutes. During one flight, the vertical climb was set at 1,800, using my Ezdok Camera, I went back later and it was off. The flaps handle can only go down , not up. Some switches can only go to the left, but not back to right.Not all buttons and switches are affected. A side note, when I hover over a switch or button, the little box does not appear showing me what it is. This could be something with PMDG, not sure.

  I know how to work the courser and have tried every angle with some of the switches and just can't get them to move back.

[Jim Young 2,356]

Did you install SP1c?  These switches all work properly so suggest an uninstall/reinstall.  You must have Cockpit Tooltips enabled under the Aircraft tab in FSX for info about a switch or gauge.

 

Best regards,

Jim