Hi,

 

Could somebody tell me what i'm doing wrong. Even though all switches are on this alarm "ESS 0.0" keep flashing red. (from cold and dark start up).

If i use the "ready to taxi" option, i don't have this alarm. Many thanks and best regards

Its something that started happening after SP2......

 

Work in the pressing of the main and stdby reset buttons above the main batt switch into your pre-power up checklist...... If you power up and still get the fault, power electrical system down and press the reset buttons again...then start power up procedures again....

i tried to reset the reset switches and it still does not turn the ess bus lights off

Make sure the G1000 is off before you power down the main / batt....