Hi,

I am using Ultimate Traffic 2 for Airline AI traffic and Traffic X for GA traffic as suggested by several users. I have Airline traffic enabled within UT2 and they show up fine. I have the Daily slider at zero in UT2 which I was told controls the GA traffic in UT2, and the GA slider in FSX at 50% since I am assuming the FSX GA slider controls the Traffic X traffic. I am showing plenty of airline traffic but no GA traffic. The Traffic X manual only says to adjust the slider in FSX. Any ideas?  Thanks.  Tom

Do you have the following line in the Main section of your fsx.cfg - SimObjectPaths.6=MyTraffic\Aircraft?

 

Is MyTrafficX located in your Scenery Library?

 

Best regards,

Jim

Hi Jim,

Thanks for the help. In my FSX Cfg. I have two lines for Ultimate Traffic and Traffic X:  "Simobjectpaths.6=Simo0bjects\ UT2 Aircraft "  and "Simobjectpaths.7=simobjects\TrafficX".

 

In the Scenery Library I have "TrafficX Airport Facilities" with a priority of 2. I have the GA slider in FSX at 100%, (0 Daily Slider in UT2) and am using KORL Orlando Executive and Teterboro to check. Thanks again,  Tom

Just wanted to make sure.  You are doing something out of the norm so I cannot help you further.  In my FSX directory, I have FSX\MyTraffic\Scenery.  You must have set up a special folder just for your GA aircraft.

 

Best regards,

Jim