Hi All,

         I have been reading the DX10 forums for a while now and have just taken the leap into changing over.

 

I have managed to get everything setup well so get 20-25 fps with PMDG 737ngx in busy airports which is what I was after.

 

However one problem has arisen.  I have and use VoxATC in combination with MyTraffic 2013 yet since the move to DX10 VoxATC no longer displays any AI aircraft.  VoxATC loads perfectly fine and operates how it should do except I no longer see any aircraft!

 

Can anyone help with this.  As far as I am aware MyTraffic 2013 is DX10 compatible and VoxATC only loads the aircraft into the sim so I cannot understand why the aircraft do not display.

 

Has anyone any ideas.

 

Any help is much appreciated.

 

Thanks

And without VoX, do you get to see your MYTraffic AI planes if you use default traffic?

 

I have used the VoxATC demo (6.2) for a week and it worked perfectly with DX10. My traffic at that time was TrafficX.

Hi "Kennedy"; Did you create a new fsx.cfg in moving to DX10? If so - check out the [Main] section, and look for the added line, in my case I use MyTrafficX, and so MTX adds line #6:-

 

[Main]

User Objects=Airplane, Helicopter

SimObjectPaths.0=SimObjects\Airplanes

SimObjectPaths.1=SimObjects\Rotorcraft

SimObjectPaths.2=SimObjects\GroundVehicles

SimObjectPaths.3=SimObjects\Boats

SimObjectPaths.4=SimObjects\Animals

SimObjectPaths.5=SimObjects\Misc

SimObjectPaths.6=MyTraffic\Aircraft

 

 

If it's missing - you've just found the cause!

Thanks Paul, that was it!

 

I did create a new fsx.cfg when going to DX10 and never thought about what changes had been put in their by MTX.

 

Thank you for the help.

And without VoX, do you get to see your MYTraffic AI planes if you use default traffic?

 

I have used the VoxATC demo (6.2) for a week and it worked perfectly with DX10. My traffic at that time was TrafficX.

Hi Mork, sorry forgot to mention I had tried it without VoxATC with no luck.