Hi,

 

I posted the below on the official P3D forum but maybe someone here can help.

 

On the Saitek Yoke there is a mode wheel behind the right hand side handle that reports DX buttons 9, 10 or 11 depending on it's position. This can be verified in the Windows calibration section.

In P3D v2 ALL of the switches on the attached throttle quadrant (the one that use the DIN type connection) also report either 9, 10 or 11 depending on the position of the yoke mode wheel. What this means is that I cannot map any functions in P3D v2 to any of the switches on the attached Saitek throttle.

 

I also have a second Saitek throttle quadrant but this is a USB version. This works fine.

 

Just to clarify that all of the switches report as expected in Windows device setup/calibration.

 

Any help appreciated.

 

Daz

I have this exact same issue Daz. Hopefully, with my reply, this will be moved up fresh and some one will have found a solution in the past 6 weeks since your original post.