January 12, 201412 yr i am trying to make example flight. during the take off, and even cruising, throttle quadrant keeps triyng to retard. i have to push it constantly. what am i doing wrong? Cenk Demir Besiktas JK 1903
January 12, 201412 yr Commercial Member You have a conflict of some sort, either with another input device or calibration software.If you are using FSUIPC be sure that you only have your desired throttle quad linked to the power lever and condition levers axii for the Dash. Also verify that your control panel settings are properly configured KROSWYND a.k.a KILO_WHISKEYMajestic Software Development/Support Sys 1: AMD 7950X3D, NOCTUA D15S, Gigabyte Elite B650, MSI 4090, 64Gb Ram, Corsair 850 Power Supply, 2x2TB M.2 Samsung 980s, 1x4TB WDD M.2, 6xNoctua 120mm case fans, LG C2 55" OLED running at 120Hz for the monitor, Win11. Sys 2: i7 8700k, MSI GAMING MBoard, 32Gigs RAM, MSI 4070Ti & EVGA 1080Ti. Hardware: Brunner CLS-E-NG Yoke, Fulcrum One yoke, TM TPR Rudder Pedals, Yoko TQ6+ NEO, StreamDeck, Tobii Eye Tracker, Virpil VPC MongoosT-50CM3 Base with a TM gripSIMULATORS: MSFS2020/XP12/P3D v5.4 & v6: YouTube Videos
January 17, 201412 yr I had the same issue - long story short - I have two Saitek Cessna Throttle Quads. An old assignment of the mixture 1 lever "switch" or "full down" position was assigned to "Throttle Decr Increments" or something similar to that. Whenever that lever was in that full down position, the actual throttle assignments reacted accordingly by reducing. I deleted the old assignment which corrected the problem. If you follow what the previous writer suggested and make sure there aren't any old FSUIPC assignments, you should clear this fault. Let folks know if your efforts were successful or not, OK? Mark
Create an account or sign in to comment