February 12, 201412 yr when i start the engine (no dark and cold panel) Fuel flow indicator is 0.0 - What am I do wrong or forgotten? All procedures APU etc etc etc is Ok. Regards Rezende
February 13, 201412 yr Sounds like it might be a problem with your default FSX flight. This defines the aircraft you see in the window when you load FSX. This should be an FSX default aircraft like the trike or C172. Then select the NGX and click Fly Now. Make sure you set it up as per the PMDG introduction manual. Check you have no faults active and the fire handles are not pulled. Then as long as you have fuel in the tanks, electrical power available and sufficient N2 there should be fuel flow when you open the start lever. Sent from my iPhone using Tapatalk
February 13, 201412 yr Hi, Have you changed your fuel filters?....changed your 2 sparking plugs.(2 per each engine)..no bleed air leaks in the tubes between APU bleed manifold and engine starters? Have you switched off your packs?...sorry I was jocking, as Kevin has said problably a problem with your default fsx flight... Ciao Andrea Buono
Create an account or sign in to comment