Saitek TPM cannot asign switches

[motoadve 49]

The Throttle, Prop and Mix axes are asigned no problem, but there are 9 switches and when I try to asign a function, and move the switch prepar 3D doesnt recognize it.

[turner112 52]

Hi motoadve -

 

I had this issue and found in my case that even if there wasn't anything apparently assigned to a switch, it still had to be cleared first.

 

Also, I cleared all other assignments for the same control.

 

The button assignment system seemed a little buggy, but as long as I cleared all current assignments, even if only one and it didn't visibly have an assignment, it worked.

 

Hope that helps!

 

cheers

Andrew

[RelaxX 11]

I have the same problem with my Saitek X52 Pro controller.

 

I run P3D v2.2 (patched) with Win 8.1 64 bit. I habe deleted the 4 folders as suggested by LM.

 

 

[motoadve 49]

Thanks, it worked but only with the top 3 switches.

 

The ones below get recognized as being the top ones and when I asign a new command replaces the ones on the top switches.

[turner112 52]

Hmmm... are you clearing them first too?

[motoadve 49]

Yes clearing them too.

Also I created a profile in the Saitek software, imported it to prepar 3D and now none of the switches work :(