Have downloaded & installed Mooney by Tomislav Stimac. Nice to have the ADF & other goodies, however, there is no mini-panel on cycle through views with the W key. Have contacted Tomislav and he is sorry for the omission."HiI'm sorry for non complete version. It is my fault. Ididnt took time to check it all. If there will be somenew version, i will include the second (minimal) paneltoo. There will be no updates to this one, as avsimstuff don't like updates too much. Well, me neither,as they create a lot of mess and confusion (speciallyto new users - beginners).There might be some new panel, with some new texture,and i'll make sure, this mistake doesnt happen again.Regards from Croatia (Europe)Tomislav--- edwin brown wrote:> Goodmorning Tomislav: Have downloaded your> Mooney_Bravo.ADF and am very pleased to finally have> the ADF and other goodies. Thanks for your effort.> However --- I am used to pressing the W key to cycle> through the three different views. ie; full panel,> partial panel and no panel. I can't get the second> partial panel view, only two no panel views and a> full panel on three key presses. Something missing??> I went through the installation twice and still get> the same results.> Hope you can help me figure this out as the Mooney> is one of my favorites. Coming to you from Westbank> British Columbia Canada."Can someone tell me how to edit whatever is needed to get the mini-panel view? Maybe I'm in the wrong forum for this but any direction would be helpful.

>Can someone tell me how to edit whatever is needed to get the>mini-panel view? Maybe I'm in the wrong forum for this but any>direction would be helpful.Well, the Aircraft & Panel Design forum would be the best place to post the question, but......unless there's a "minipanel" explicitly declared in the panel.cfg file, FS will use the "minipanel" found in the defaultpanelpanel.cfg file.There must then be a problem with that specific model's panel.cfg file, if it is not allowing the default "minipanel" to display.