Hi

when I load a flight plan and enable voxatc,the radio check goes fine but it seems to skip atis and goes to ground. Am I mising something in the correct set up sequence as far as loading and saving the flight plan. 

  Could someone tell me the definitive setup sequence or point me to a previous thread that gives this info of plan plan saving and loading  and enabling vox atc. I have seen different ones. 

thx Lee

Lee,

 

What is your flight plan?

FSX?

 

Did you do the sample VFR and IFR flights?

I did the ifr flight and it went fine.

What was your FSX flight plan ... the one that failed?

EgnsKelly L10 wal egbb

With majestic q400

Lee,

 

Page 10 of the user manual talks about ATIS.

 

If it worked on the sample training flight it should work the same way on your next flight.

 

"EgnsKelly L10 wal egbb"

This tells me nothing. I do not understand it.

 

 

I need to see a copy of the FSX flight plan you used.

In FSX after I Enable VOXatc it takes about 2 minutes for the voices sets and VOXatc to finish its setup.

Then I see aircraft (AI) show up at various parking spots.

 

Then I get an ATIS Pop-Up screen.

https://www.dropbox.com/s/78guocdabdikjp4/VOXatc-ATIS.jpg

 

Do you get one?

Please excuse my confusion. I thought you wanted the route. If you want the .pln file i will get that to you after work. When i pressed enable it went straight to clearance frequency.

I will give it another go later today.

Thx Lee

Lee,

 

"If you want the .pln file i will get that to you after work"

Ok, I thought you were at your PC ready to check stuff out.

 

Try the sample IFR flight first afte you get back to your home PC.

 

Route? "EgnsKelly L10 wal egbb"

What is EgnsKelly?

 

I know EGBB .

Just did ifr tutorial flight and it went flawlessly. Maybe it's the way I loaded the flight leaving egns (isle of man).

I will try again. Obviously voxatc is working.

I will let you know

thx for all you help

Lee,

 

Have a good flight.