I've been following this tutorial http://www.youtube.com/watch?v=EUacZAVwN1I on youtube. Each I prep my fmc Ive been running into the same problem when I want to take off from KPAE. I have no SIDS. What am I doing wrong!

 

LikeLike ·  · Share

 

There is only one SID for KPAE - Paine 2.  It's a pure vectored SID so it isn't going to show up in the nav data - in general you fly runway heading until getting vectors to your assigned route.

 

DJ

 

 

There is only one SID for KPAE - Paine 2. It's a pure vectored SID so it isn't going to show up in the nav data

 

Actually... in an older Navigraph I have (Cycle 1210) PAINE TWO shows up there (can be loaded in the B737 FMC).

Yes, it did - and it gave precisely the departure instructions that I mentioned above with the exception of the addition of a fictional conditional waypoint at about 1000 feet and VECTORS following; kind of useless really and the newer Navigraph data doesn't include it.  If you use NavdataPro you can still get Paine 2 just as in the 1210 data.  Nonetheless, the lack of this sort of SID in the Navigraph data is the reason the OP doesn't see it.

 

DJ

 

 

and it gave precisely the departure instructions that I mentioned above

But that irrelevant to the OP's question...

 

kind of useless really

also irrelevant to the OP's question...

 

and the newer Navigraph data doesn't include it.

This would be the kind of information that would answer the OP's question if he is using Navigraph... that the PAINE TWO DP is no longer included.

Why I posted the old cycle info... to see if someone could check if that was the case with the newer cycles.

 

Thanks for checking.