Hey guys, 

 

So purchased FSPSFA a few days after it was released, and found it be a Fantastic tool. In the Sim i have FPS set to 35, and then in the tool itself i have it set to 30. 

 

I find when on approach, when FSPS swicthes my FPS from the Locked number to unlimited, the ground textures go blurry as... When i switch to the wing view, and the FPS goes back to locked, the Textures begin to look nice and crisp again. It only seems to switch to unlimited when im in the VC of aircraft like the NGX and now the 777 300!

 

Is it trying to tell me that it cant hold the locked number ? Should i try putting the FPS down abit and see if it will clear up the textures... Or is there any tweak any one have used to Un blurr the textures..

 

System is - I5 4670K 4.4ghz, GTX 770, 8GB of ram..

 

Tweak wise, just using the normal Bufferpools =0,highmemfix, Affinity mask.... 

Yes you should set a lower frame rate value until the unlimited rarely appears.

 

However, in my case, with my system, this value tends to be very low, so low as to lead to an unsmooth flight and I still get the blurries,  I just can't take that slow and blurries so I have shelved this application for the time being.

 

BTW...there is already an ongoing tread about the experiences of users with FA v1.2 here..

 

http://forum.avsim.net/topic/446505-fsx-fiber-accelerator-v12/#entry3032173

 

Although sometimes I realize it is better to post specific questions in their own thread so that you can get a specific answer to a question.

 

Bryan