Saitek Hat Switch And Ezdok

[Driver170 42]

Hi its my USB it keeps on cutting out maybe i have to update the USB driver?

 

My build is only 3 months old i'll check out asus Z87-A for updates.

[AVSIM Admin 4]

This is an automatic message.

 

This topic has been moved from "MS FSX Forum" to "Hardware Controllers & Drivers". This move has been done for a number of possible reasons.

• The most likely reason is that the post was off topic.
• The topic could also have contained images or a video that were not appropriate to the original forum it was posted in.
• The images might not have been "illustrative" or "explanatory" in nature.
• The topic could have been moved because we deemed it to be more appropriately placed elsewhere.

Please ensure that your posts are "on topic" and contain illustrative images or videos as appropriate. Do not post videos or images just for entertainment purposes anywhere but in the screen shot or video forums. See our image posting rules here.

 

Members who continue to post off topic posts can be denied entry to specific forums in order to reduce and remove the practice. Your cooperation is appreciated.

[Driver170 42]

Found the cause i recently put a mini fridge on the same plug and adapter and each time the fridge would blink out because of temp control it was knocking out my USB and disconnecting my saitek. I removed the fridge and its been over an hour and no cutouts

[KingGhidorah 209]

Did removal of the mini fridge also happen to fix your MyTraffic X problems?

 

This is good that you found this.  The next thing I was going to propose was clearing CMOS by pushing the button on your motherboard!

[Driver170 42]

Haha i got it installed but at the end of the installation it didn't finish so had to go into the folder and run a bat file called runonce to install the planes but there is also another file called rebuild_mytraffic?

 

Still can't go back to 2012 schedule!

[Jack_Sawyer 4,600]

Hello, I have the Saitek Proflight yoke, quadrant and pedals.

 

I have FSX Gold.

Win 7 64

 

Tonight I bought EZCA and installed it and watched some videos on how to set it up.

 

It's easy to set up but if I assign a camera view to my yoke buttons it's global.

 

Is there a way to set it up for just say Mode 2 or Mode 3?

I use the Saitek controller software.

 

Any help would be much appreciated.

 

Thanks.

[pito253 0]

I have my right view set up with my hat-switch and when i click on it it uncheck the check mark in the box  in configure joysticks option does any one know how to fix this so when i use my hat switch to view my Right view it doesn't uncheck it 

 

                                                                                                                                                     Thank You