Hi guys,

 

I have two issues with GTN integration in the C310...

 

One is the altimeter issue already reported in your forums: with the GTN750 panel variation, the hundreds digit stays pegged at 9. I can see the issue is also present in Fr. Bill's screenshot in the autopilot thread here.

 

The other one is that I'm unable to use the GTN750's panning functionality in the VC. I can pan the screen in pop-up mode, but in the 3D VC, the pan mode engages, but the map doesn't move.

 

I'm running the C310 in FSX.

 

Tym

I suspect the hundreds digit got 'broken' when compiling the new interior model. I'll have to take a closer look to see what's wrong.

 

As for the panning of the 750 in the VC, I've had no problem with that. The 'rubber band editing mode' also works quite well!

Thanks for the reply, I look forward to what you come up with regarding the MDL.

 

Regarding the panning issue, I've got some interesting replies in the F1 forum (http://www.simforums.com/forums/topic50011_post309165.html). Did this feature work for you in FSX or in P3D2? If P3D, what version are you using? It'd be a good idea to try and narrow it down...

 

Thanks again!

Tym

I suspect the hundreds digit got 'broken' when compiling the new interior model. I'll have to take a closer look to see what's wrong.

 

As for the panning of the 750 in the VC, I've had no problem with that. The 'rubber band editing mode' also works quite well!

Hi...could you tell me if Milviz is looking into the problems that some are having, myself included, where the Autopilot will not work after installing the GTN units into the cockpits. It has been reported in a couple of different places but have not seen any indication that it has been looked into. Please not that the 650 and 750 work fine using popups. The problem only shows up when using the patch to place them into the panel.