After some experimenting I have LINDA working with my PMDG 737-NGX and my EFIS connected to the Leo Bodnar BU0836X card. Everthing is working fine except for an annoying issue with the BARO IN/HPA selector. When I move the encoder (EMLA E37) very slowly, the selector works without issues. However, if I move it clockwise clockwise a bit faster, the HPA is selected but the View Change is also executed. When I move it counterclockwise, the IN is selected but the Parking Brake is engaged or disengaged. I don't have this issue with the MINS switch.

 

Could this be something where LINDA executes the commands correctly but something else is triggering the FSX Control?

 

Thanks,

Steve

 

 

Could this be something where LINDA executes the commands correctly but something else is triggering the FSX Control?

 

Yes, you should make sure, theres no double assignment to the "fast" rotation option of your device. You have probably two modes for dialing: slow and fast.

 

Have a look if it is assigned in FSX still or maybe also in FSUIPC or if there's some other software.

Thanks Guenter.  I used Leo's config tool to set the pulse rate. Is that what you mean by 'fast' rotation? Otherwise I don't know how to set the rotation speed.

 

I did find that I had double assignments for the View Change and resolved that issue. The Parking Brake (set parking) is only assigned to keyboard "1" but i have brakes set to button 1. When I rotate the knob clockwise, sometimes it will release the parking brake. It never SETs the parking brake and Brakes doesn't show up in the lower left corner of my screen. Can't figure out what is causing this.