I have done a lot of reading about getting various add-on's to work with Steam. For the most part I got the LevelD 767 to work, except when I try to enter information into the FMC.

I'm unable to enter in the gross weight, the ZFW, or the T.O. trim info. For the gross weight, and the ZFW? I get a invalid entry on the note pad. When I try to enter the T.O. trim? nothing happens. All other switches, and buttons seem to work. Any idea's on what may be causing this?

 

 

Issue has been resolved.

Issue has been resolved.

 

May I ask you how?

Level-D 767 is the only model I have not yet installed after switching to FSX-SE. I would appreciate any useful information.

After a lot of reading on various sites, I checked the International section under general settings. The unit of measure needs to be set as US system. some how my system setup as Hybrid.

I hope this helps you out?

Thanks a lot, Delta. I will install the Level-D 767 under FSX-SE and will take this information into account.
Have a nice day.

 

 

May I ask you how?
Level-D 767 is the only model I have not yet installed after switching to FSX-SE. I would appreciate any useful information.

 

If you are asking a general question about how to install the Level-D In FSX:SE, there is a thread a few entries below this one.

 

Mike