Hi,

 

im using P3D v3 and i recently installed 3 monitors and i do have some troubles setting them up.

 

Im using a GTX960 with 3 seperate monitors in the NVIDIA controlpanel - so no Sourround Spanning is used.

The middle Monitor runs at 1920x1200 and the other two (left and right) at 1920x1080.

 

When im running P3D I change the window size of P3D so that the window is one big window spanning over the 3 monitors.

 

Everything´s fine till now, but when im loading a plane im way too close regarding the zoom level. it is at 0.3 which works in single monitor mode perfectly, but on the 3 TFTs im way too close "in the cockpit", so that i can either see whats going on outside or i can see the instruments. i cant zoom out so that i can see both, like in single monitor mode.

 

the more i stretch P3D the more it zooms in optically - the technical zoom factor stays the same - 0.3.

 

is there any solution tweaking a *.cfg file or something like that?

 

 

thx in advance!

sorry for mistakes - english is not my mother tongue.

 

best regards 

tom

Tom:

I have a similar setup.

You need to go to 'Settings -> Display -> View & Panel Settings -> Wide-view Aspect Ratio' and make sure the box is checked.

 

This will let you zoom back to a more realistic position.

 

-david-

Hi David!

 

You made my day! Thx very much - that was the solution!

 

best regards!

Tom