FS 2004 and CH USB 3 lever Throttle quadrant, please could I ask for advice, when I advance my 3 levers on the Throttle forwards to begin the takeoff roll my engines spool down and stop I'm not sure if I need to correct my settings in Assignments  or if it is something I need to adjust with my FS2004 any advice would be most appreciated

 

Many Thanks

  Richard

I have never seen a CH 3 lever throttle quad ?

 

Anyway, you should assign and calibrate the levers in FS9. Sounds like one of them is operating as "mixture control".

Hi Thank you for helping me out, you were right when I advanced the Throttle Axis lever & Propeller Axis Lever no problems but when I took the lever I assigned to Mixture Axis back the engines spooled down, so i've disabled the Mixture Axis and it seems okay

CH Products make a CH USB Yoke with 3 levers guess its a bit dated by now.

Thank you very much

  Richard