Shockwave Lights for the Phenom 300

[raymie 81]

I just purchased the A2A Shockwave lights for FSX and was wondering if anyone has installed them into this aircraft? I have not yet tried to install these lights myself. If anyone has, could you please share your installation specs for both a\c cfg. and panel cfg. files? 

 

Thanks,

 

Raymie

[Louis8 6]

I found this for you --- I'm gonna try it also 

 

 

http://www.avsim.com/topic/450557-phenom-3d-shockwave-lights-setup-for-you/

[raymie 81]

Hi Louis,

 

Thanks for your reply and the link you posted. Unfortunately that application is for the 100 model. I tried it and there's a significant difference between the 100 & 300 models.

 

Raymie

[raymie 81]

Hi Louis,

 

Here is what I found over at A2A's website regarding their Shockwave 3 D Lights Redux. After incorporating the specs for the 300 model, the Red & Green nav lights are okay on the ground, but in the air, they are a little out of place. Not sure why as I do not know much about this. Hope this helps

 

Raymie

 

Here are my Shockwave Lights configurations for the Carenado Embraer Phenom 100 and Phenom 300

Carenado Embraer Phenom 100:
Original modifications from avsim.com forum

[LIGHTS]
//Types: 1=beacon, 2=strobe, 3=navigation, 4=cockpit, 5=landing
light.0 = 10, 8.20, 0.00, 3.00, fx_vclightcarpc,
light.1 = 10, 1.80, 0.00, 1.80, fx_vclightcarpcvc,
light.2 = 3, -2.0, -21.0, -.5, fx_shockwave_navred
light.3 = 3, -2.0, 21.0, -.5, fx_shockwave_navgre
light.4 = 1, -4.2, 0.0, 4.0, fx_shockwave_beaconb_nl

***************************************************************************************

Carenado Embraer Phenom 300:

[LIGHTS]
//Types: 1=beacon, 2=strobe, 3=navigation, 4=cockpit, 5=landing
light.0 = 10, 18.20, 0.00, 3.00, fx_vclightcarpt3,
light.1 = 3, -2 ,-24.80 , 0.5 , fx_shockwave_navred
light.2 = 3, -2 , 24.80 , 0.5 , fx_shockwave_navgre
light.4 = 5, 14 ,-1.35 , -0.99 , fx_shockwave_landing_light_narrow_down_old
light.5 = 5, 14 , 1.35 , -0.99 , fx_shockwave_landing_light_narrow_down_old
light.6 = 6, 13.8 ,-1.35 , -0.8 , fx_shockwave_landing_light_narrow_down_22
light.7 = 6, 13.8 , 1.35 , -0.8 , fx_shockwave_landing_light_narrow_down_22

the Phenom 300 has four lights as landing/taxi lights. I only added two shockwave lights effects because four effects are too much light under its belly I think.

Regards

Stefan