I have uninstalled PMDG 737NGX from FSX because now I use it only in P3D.

 

The problem is that when I load SimServer that was configurated for FSX and P3D, and don't find the FSX installation, gives me an error message before been able for P3D.

 

Is there any config file where I can take away the instructions for FSX ???

 

Thanks

J J Gómez Prieto

Hi JJ,

 

yes, there is probably a reg key that is causing this. If you send me your logfile.dat, I can tell you exactly which key is causing the message.

 

Regards

Mark

OK Mark I have already send you it

 

Thanks and regards

 

J J Gómez Prieto

Thanks Mark for your answer sent to me by mail about the SimServer logfile.dat.

 

I would like to share with other users of your excellent program which was the problem and which has been your solution, in order to help them if any other had similar problem.   

 

When I uninstalled  PMDG 737NGX for FSX ( I own it for FSX and P3D but nowadays I only fly with P3D ) not all the folders and files of this aircrfat were taken out of my computer; some of them ( .......\PMDG\PMDG 737 NGX ) remain in the FSX folder and must be deleted manually.

 

With this folder in my computer, when SimServer were started I received an error message and SimServer were able perfectly but only for P3D ... not other effect.

 

Mark advise me to delete that folder and this is the best solution, but I have found that is also a possible solution to rename the folder if you want to save the files in that folder.

 

As always Mark has given the solution in a record time and in the apropiated way

 

Thanks Mark.

 

Regards

J J Gómez Prieto