Hi!

 

I am trying to assign shortcut keys for my presets.. Tried using the general "reset  cam position" and also the direct assignment in the preset holding CTRL key.

 

Once i press my mapped key, P3D changes view category from default "On-Board (chaseplane) to next category "cockpit" and panels disappear. Then when changing presets with my mapped keys, it stays in the "cockpit" category..

 

I have tried to comment out the "HotKeySelect=xx" in all other camera definitions except Chaseplane in my cameras.cfg, and also in the airplane "aircraft.cfg", but issue remains.

 

Any ideas appreciated

 

Freddy

 

 

Hi Freddy,

 

Make sure you remove those assignments from P3D directly. they will conflict with ChasePlane if not removed properly.

 

Best Regards,

Keven

Hi Keven!

 

The keys/buttons i use for this in chaseplane are not mapped at all in p3d..

 

Strange issue!

 

Can someone weigh in here?

 

Freddy

On what aircraft are you experiencing the issue?

Hi!

 

Seems this is with all aircrafts.. once pressing the key/button assignement for reset camera ore a directly mapped key/button in the preset page, it aleays changes to next sub category in the default view menu.

 

I will try to investigate this furter tomorrow, and i will post back here.

 

Freddy

If

1. You made sure they are not assigned in the sim
2. You made sure you removed the HotKeys in the cfg files

Contact us through the alpha email, we'll try to fix it through Teamviewer

 

Best Regards,

Keven

Hi!

 

I am positive that both points you mention are fulfilled on my side here, but just in case, I will verify tomorrow (its 4:25 am here now ). I will contact you through the email.

 

Freddy

Hi again!

 

Solved my issue.. double mapping in chaseplaane and p3d caused this. Everything ok now.

 

Freddy