Not recognising Clearance Readback

[imwaite 0]

At LFMN and had problems using copilot to read back clearance. The Two of the Departure frequency is very short and this may not be recognised. There is no phrase for the copilot to say in response. Try to say myself but cannot move any further forward. Is a pain as this is stopping me using LFMN with ATC.

Any thoughts? 

Dialogue below. All done with "say it" and copilot responding.

Speedbird One Two Three Ready to Copy IFR Clearance;

Speedbird One Two Three is cleared to Lima Oscar Whiskey India, climb via the IRMA6E departure , with the IRMAR transition , then as filed.  Expect departure runway Zero Four Right.   Maintain Flight Level Two Zero Zero. Expect higher clearances Ten minutes after departure.  Departure on One Three Zero Decimal Eight Two Squawk Three Zero Six Four

 Speedbird One Two Three is cleared to Lima Oscar Whiskey India climb via the IRMA6E departure with the IRMAR transition then as filed Maintain Flight Level Two Zero Zero Expect higher clearances Ten minutes after departure Departure on One Three Zero Decimal Eight Two Squawk Three Zero Six Four;

 Readback incorrect. Speedbird One Two ThreeDeparture Frequency is One Three Zero Decimal Eight Two

If Readback incorrect, readback the elements the controller repeats to you.  Speedbird One Two Three

Thanks,

Ian

[Dave-Pilot2ATC 870]

This issue will hopefully be fixed in the upcoming 2216 update.

Dave