Engine exhaust flame animation

[FireRx 18]

Hey guys, 

is anyone else having issue not seeing the engines exhaust flame animation on the aircraft?  I set everything and all sliders to max in Prepar3D v.4 and still nothing. I even uninstalled and reinstalled it. I'm a little stumped on this one. 

[scandinavian13 5,192]

37 minutes ago, FireRx said:

uninstalled and reinstalled

Unless someone directs you to do this. It's usually wasted effort (and can cause additional issues). Avoid it unless instructed.

As far as your issue goes, dynamic lighting enabled? Using shaders/tweaks/mods?

[FireRx 18]

Dynamic is enabled.  shaders sliders are in the 80's on HDR. everything else is full right. 

 

[scandinavian13 5,192]

20 minutes ago, FireRx said:

Dynamic is enabled.  shaders sliders are in the 80's on HDR. everything else is full right. 

Okay.

Where are you trying to observe the effect? Ground? Air? Climb? Descent?

[FireRx 18]

thank Kyle, I seen it now, on Full throttle take off only.  not at all on the Ground, Cruise, or descent . 

[scandinavian13 5,192]

3 minutes ago, FireRx said:

thank Kyle, I seen it now, on Full throttle take off only.  not at all on the Ground, Cruise, or descent . 

Yeah. Keep in mind that flames coming out of the stacks would logically only happen when you're dumping copious amounts of fuel into a cylinder.

[FireRx 18]

makes perfect sense. Thank you again sir. searching for an Air Tanker livery now.