Hi, I just bought and installed the Q400, I set it up with the ECS files from EZDOK from when I had it installed in FSX and P3D3.4.

Everything works fine except for some very exaggerated movement when I taxi, if I move the tiller to the left or right the whole cockpit rolls to the extreme left or right.

I went through every CP setting and can't figure out how to stop this or minimize it.

Using the latest experimental version in P3Dv4.1.

Thanks for any suggestions or help.

 

Hi Jack,

When you first loaded the aircraft, you received the following message:

Quote

Due to the custom Flight Model in the Majestic Software Q400, Acceleration, Gyroscopic, Engines, Blast and Anticipative Motion Effects may not function properly.

So, I suggest turning the Motion Effects sliders to zero one by one to see what is causing the issue.

Regards,
Keven

11 minutes ago, Keven Menard said:

Hi Jack,

When you first loaded the aircraft, you received the following message:

So, I suggest turning the Motion Effects sliders to zero one by one to see what is causing the issue.

Regards,
Keven

Thanks Keven, I think I pulled all the sliders down and no help but I'll try again as soon as I am able and let you know.

5 hours ago, Keven Menard said:

Hi Jack,

When you first loaded the aircraft, you received the following message:

So, I suggest turning the Motion Effects sliders to zero one by one to see what is causing the issue.

Regards,
Keven

Thanks Keven, just had a chance to test it.

It turned out to be Anticipation.  It was set to 1.0 so I set it to 0 and now it doesn't behave this way.