Mr John McWilliam

[jsmcwilliam 3]

1. I run under Windows10 and have recently upgraded to P3DV4 with the assoc. PMDG 737 and FS2Crew. During the before start checklist when asked for Rudder and Aileron Trim there was no response. The response: Set and Checked got me past the problem.

2. Into the Initial Climb I was asked twice if the I was "Happy to release the cabin". After that no problem.

3. After setting STD pressure there was a repeating voice: "Altimeter setting". I managed to stop that by switching to local pressure and back a couple of times.

Your comments would be interesting!

John McWilliam

 

[byork 2,259]

Hi John,

1. Make sure you're using the phrase listed in the manual.  It needs to show up in the green bar.  Maybe consider running the voice training again.

But you did good with "Set and Checked"... that's backup phrase in case you get stuck.

 

2. They sound similar, but they're not exactly the same.  One is for releasing the FAs so they can start offering you drinks and selling you stuff.  The other is for the pax to get up and walk around.

 

3. That's coming from RAAS I think.   Check you RAAS options / settings in the ADDONS menu.

 

[jsmcwilliam 3]

Thanks for the response.

1. Checked the manual and the response is under Before Start Checklist: "Free and Zero",however, this does not register as green text and I have to use "Set & Checked" to get past this. Not a major problem.

2. OK

3. OK

Thanks again.

[byork 2,259]

1. Try running the voice training and again.  Adjust your voice a bit until "free and zero" shows up.  Change your pronunciation a tad.