February 25, 20188 yr I want to set the hat switch on my Saitek Yoke to Chaseplane but I cannot set to the 8 points only pan left/pan right are available assignments - Any suggestions? I do see there is an issue with panning in P3d - https://prepar3d.com/forum/viewtopic.php?f=6312&t=128468&start=30 P3D Settings: The Look(Pan) is assigned to Hat Switch 1 Input Method>Direct Lyle Jayma
February 25, 20188 yr Commercial Member Assign Pan Left/Right and Tilt Up/Down to accomplish what you are trying to do. Make sure you remove the assignment from P3D to prevent conflicts. Keven Menard Technical Director, //42.
Archived
This topic is now archived and is closed to further replies.