June 4, 20188 yr I like to start a session with the aircraft always in the Cold & Dark state. Through the CDU I am able to define the situation. If I close the session and then start a new one the Cold & Dark state is not kept, as the aircraft starts with even engines on. What have I to do in order to start my session in a C&D situation? Regards, Domingos Nunes
June 4, 20188 yr Commercial Member 1 hour ago, dnunes said: I like to start a session with the aircraft always in the Cold & Dark state. Through the CDU I am able to define the situation. If I close the session and then start a new one the Cold & Dark state is not kept, as the aircraft starts with even engines on. What have I to do in order to start my session in a C&D situation? Regards, Domingos Nunes You need to set it as Startup panel state. Check the Introduction document page 69 Chris Makris PLEASE NOTE PMDG HAS DEPARTED AVSIM You can find us at http://forum.pmdg.com
June 4, 20188 yr One or two LSK below the "load panel state" LSK is a default setting. choose it there. Chris was faster 😄 Edited June 4, 20188 yr by Ephedrin ,
June 4, 20188 yr Author Thanks Marc and Chris! That was it. Now I have a Cold & Dark start as I like to see. Regards, Domingos
Archived
This topic is now archived and is closed to further replies.