Two Saitek Pro Yoke on same P3D v4.x

[Claudio Borlotti 0]

Hello everyone,
I want ask if is possible to use 2 Saitek pro yoke on the same Pc with P3D V4 because i want to simulate the Captain and First Officer position, and other question, is  possible to use the 2 throttle quadrant for mixed the control, left engine - right engine - spoilers and flaps (6 channel) ? 

Thanks for your help!
Bye
Denis

[MaDDogz 242]

2 throttles = yes

2 yokes I’m not sure it would work, it may cause a conflict

[Nickbe 401]

2 yokes work together without conflicts if you configure them directly through FSUIPC.

But of course not work synchronously. Control will be intercepted.

Edited June 22, 2018 by Nickbe

[Claudio Borlotti 0]

Thanks a lot for your response guys, I will try to configure 😁
Best Regards.

Denis

 

 

[Pete Dowson 558]

2 hours ago, Nickbe said:

2 yokes work together without conflicts if you configure them directly through FSUIPC.

But of course not work synchronously. Control will be intercepted.

With FSUIPC assignment, the one with the most displacement from centre will be the one used. So if the Pilot Not Flying kept his hands off, and the central zone was calibrated properly with no serious jitter, then they'd work well together. Rudders too.

Pete