August 30, 20187 yr Hi, in FL340. Suddenly the aircraft loos control, the vnav and lnav disengage with the AP and it start to fall down in rolling. It happens when I slide the VC from left to right, it happens sometimes. can someone help me? regards Aviv Shafer avivpsm
August 30, 20187 yr Most likely you have controls assigned to axes or buttons on your hardware.. FSX and P3D do that to all controllers they can find. Even virtual axes on gaming mouses etc. Go through your controls assignments and delete everything you don‘t need. Every axis should be there only once. And if you have Fsuipc remove the dll temporarily from the modules folder to check if that works. A third and forth possibility are misconfigured weather programs or broken hardware (but i‘d bet on the first two) ,
August 30, 20187 yr Agreed you have to be very careful about what axis are assigned to what, and they only way to know for sure is to go into controls for every input device listed in the drop-down, and make sure there are no redundancies, and if found, remove the unnecessary ones. I'd like to see a future version of Prepar3D revamp their hardware interface, in a graphical way that also reports any redundant axis settings explicitly. I've also wrestled with plenty of redundant settings not just related to axis, but also control assignments. Good luck. Mark Trainer Mark Trainer
September 2, 20187 yr On 8/30/2018 at 8:40 PM, psp5213 said: It happens when I slide the VC from left to right, it happens sometimes. How are you sliding the VC from left to right? If you are using Ezdok that has been known to upset the flight dynamics.
Archived
This topic is now archived and is closed to further replies.