744 panel state

[alex1121]

Hello,

after the last update, i've found that the cold and dark panel state for some versions of the 744 is not correctly configured.

Both clocks are on run,

IRS  and AIR DATA knobs are on C position

INBD CRT is on PFD (but dispalys as NORM)

Here is a screenshot 

[scandinavian13]

44 minutes ago, Alessio Calandrella said:

after the last update, i've found that the cold and dark panel state for some versions of the 744 is not correctly configured.

Yeah. The panel states are meant to be compatible with the 744 and 748, but the handling didn't get set up properly, apparently. This is corrected in the update that should go out in the next few days.

In the meantime, load a flight without using a panel state, and then save a new one in the config you desire.

[alex1121]

3 hours ago, scandinavian13 said:

Yeah. The panel states are meant to be compatible with the 744 and 748, but the handling didn't get set up properly, apparently. This is corrected in the update that should go out in the next few days.

In the meantime, load a flight without using a panel state, and then save a new one in the config you desire.

Thanks for your job sir!