January 12, 20197 yr Hello, I have the latest Chaseplane version (1.0.24) installed with P3D 4.4. There is now the following odd behaviour: Whenever I manually zoom in or out with the +/- keys the viewe autmotically jumps back to the Chaseplane preset fromwhere I have started the manual zoom in or out. This alwas happens after about 10-15 seconds. This happens NOT depending on the aircraft, but only when Chaseplane is active. What could cause this and how could remove this odd behaviour? Best regards, Oli
January 14, 20197 yr Commercial Member Make sure you use the zoom controls in ChasePlane, not in P3D Keven Menard Technical Director, //42.
April 13, 20197 yr Looks I have the same problem. Could you please advise how to check it what zoom is in use? I am just a beiginer P3dv4 user.
April 17, 20197 yr You should either: Remove the zoom function in P3D for the +/- keys, then assign these keys to the zoom in/out commands under 'Control Assignments' in ChasePlane instead. or Assign controller buttons or alternative keyboard keys (perhaps +/- on the Numpad) to the ChasePlane zoom controls, and use those instead of the regular +/- keys. Martyn French
Archived
This topic is now archived and is closed to further replies.