claplata

Diagma simulator with the hardware for the G530 (resolved)

Recommended Posts

I recently purchased the G530 v 2 from RXP to replace the default G530 from the Cessna 172SP in X Plane 11.  I have installed both the trainer and plugin and see the G530 listed as a plugin in X Plane, but I do not know how to configure the buttons on my hardware to control the RXP G530.  I have a new Diagma simulator with the hardware for the G530.  I had it working great with the default XPlane 11 G530.  Do I need to remove the default X Plane 11 Garmin?

Share this post


Link to post
Share on other sites
Help AVSIM continue to serve you!
Please donate today!

Hi,

I was hoping someone else with same hardware could chime in.

I'm not sure what hardware this is but I'm certain the hardware vendor shall have a 'config' doc of some sort to help you finding out how do they 'map' their hardware buttons to actual X-Plane commands?

From there, you'd just have to either map the buttons to the RXP GNS V2 commands, or even maybe just enable 'Use Simulator GPS Commands' in the RXP GNS Configuration Panel to intercept the defaults.

Share this post


Link to post
Share on other sites

Thank you, I was able to figure it out.  I didn't realize the new RXP configuration options were in the joystick config options right along side the X plane config options for the GPS.  

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now