May 30, 20197 yr Hi, i'm new here and i may be searching in the wrong place, i recently purchased a used CH products USB flight sim yoke with hopes to use it with Microsoft flight simulator X for a bit more realistic practice for my airwork. I set it up with flight sim and all controls work perfectly except for elevator pitch, the yoke doesn't recognized any pitching motion when i pull up or push down on the control column. I went on CH products website and downloaded their calibration software but there too, it doesn't recognize any movement about the pitching axis, its like i'm not doing anything, if anyone is familiar with this product any help is appreciated thanks
May 30, 20197 yr Administrators I have moved you into the appropriate forum for your question. I hope you didn't spend too much on this "used" product. Sounds like a possible broken wire or bad variable resistor/sensor for the elevator movement since you say even the CH Products calibration software doesn't detect the movement either. Charlie AronAVSIM Board of Directors-ADMIN/Moderator-RegistrarJust going to run a Chromebook and not upgrade to a Windows computer. Too many problems with the new Sims! 😱Trying to keep peace and harmony and the will of Landru on the site seems to be a full time job!
June 2, 20197 yr I have an Eclipse yoke and I agree with charliearon. If the calibration software and also Windows' game controller setup can't detect you pushing and pulling the yoke, it's broken. Get a refund or exchange immediately. Sim: Prepar3D 5.2 (main) and Microsoft Flight Simulator (2020), CH Eclipse Yoke, Thrustmaster Airbus TCA Side Stick, CH Pro Throttle, CH Pro Pedals, Saitek Cessna trim wheel, TrackIR 5, SPAD.neXt running 3 Saitek Logitech panels, ButtKicker Gamer 2, Razer Naga Chroma gaming mouse System: Intel i5-10600K CPU @ 4.10 GHz, Nvidia GeForce RTX 2080 Ti, 64GB DDR4 RAM @ 4200 MHz, ASRock Z490M Pro4, 2TB Intel NVMe SSD 660p, 3 monitors
June 5, 20197 yr Open the Yoke and check the connecting end tabs. I had one loose on mine. Bind the end tab a bit to have more pressure on the connector. Mike Mike Lab WIN10 / I7-6700K HT ON / GTX980 / 16 GB RAM / 3 x SAMSUNG EVO 1TB SSD / 1 X WD BLACK 2TB HDD / 32" 60hz Monitor @ 2560x1440 / P3Dv4.4 No AM, Locked to 59 FPS, VSync ON, Triple buffering enabled Process Lasso used to unload all other applications than P3D running on core 0
Archived
This topic is now archived and is closed to further replies.