Single engine taxi on arrival

[Captain Campion 7]

Hello. really loving this product, but i'm having problems with PM turning off engine 2. Of seven flights i have only managed it once, and can't figure out what the problem is.

After landing i exit the runway and stop the plane, follow the after landing flow and make the after landing checklist. However when i say "shutdown engine 2" nothing happens, even when i can read in the green text that the message has been understood. Only once managed to get the PM to obey the command (and he turned the electric pump afterwards).

I use the chrono to ensure the 3 minute cooldown period, any help appreciated with this. What does the program check for this procedure?

[byork 2,259]

Glad you like it 🙂

V1.1 will make it even better.

 

Conditions are:

1.Airplane on ground

2: Mode = After Landing Checklist or <<Parking>>

3. Engine 2 Master Switch in On position

 

So what mode were you in as shown on the FS2Crew Main Panel?

To test it, you can start the plane with the engines running and skip direct to either of these modes using the arrow button on the main panel.

Cheers