August 5, 20196 yr I'm not too sure if this is where i post this question but recently I purchased a yoke and throttle from logitech and it came with programming software. On the throttle quadrant there are buttons at the bottom which i was wondering if i could use those to switch profiles so that i can use one axis for mixture but if i press a button i can then use that same axis for flaps. Thanks!
August 5, 20196 yr Hi, moved to the hardware forum for better visibility. Welcome to AVSIM! Busdriver (Bill) KPHL 8086K @5.4GHz, EVGA GTX 1080 TI FTW3, DDR4 16GB @4000MHz, Samsung 970 NVMe (M.2) Windows 10 Pro, Samsung M.2 1TB for P3D V4.5
August 5, 20196 yr There is a tiny *Mode* wheel on the back of the right handle(at the top). It has 3 positions. You can program all 25 buttons and switches under each mode. So you actually have 75 buttons and switches to use. Check out the yoke segment on the Logitech site. Scroll down to *programing*. Bruce
Archived
This topic is now archived and is closed to further replies.