Issues with Maddog version

[Bob Scott 7,721]

Hi Marc;

  I'm having some trouble with the Maddog X version of the Remote CDU...a lot of missed screen updates where I can see the screen change on the panel when I press a key on the remote, but the iPad display does not update to match what's on the panel.

  Also, I run two side-by-side CDUs using the split-window feature in Safari.  At times, both of the CDUs will start to mirror each other on the iPad, as if one screen is being sent to both ports when it updates.  Usually it sort of goes away on its own, but sometimes I have to close the browser on the iPad and open it up again to restore proper operation.

  The PMDG versions don't have this problem.

Regards

 

[marcom 139]

Hi Bob,

are these 2 issues related to each other or are you experiencing the update problem only if you run the 2 instances side by side?

What version of the Maddog do you have installed?

Regards

Mark

[Bob Scott 7,721]

I haven't tried it with only one CDU remoted.  I will next time I fly it.

I'm running the latest release...1.5b506

[Bob Scott 7,721]

I ran it again with just one CDU on the iPad Pro, and saw the same occasional missed screen updates.  It works most of the time, but sometimes it fails to update the screen...I can see the input took effect on the CDU in-sim, but it does not make it back to the remote.  I'd say it's missing probably around ~5% of the time.  If I then tap the center of the screen area on the tablet, it updates.

P3D v4.5.13.32097 (HF2), Maddog X 1.5b506, SimServer 7.0.0.4

Regards