PMDG DC-6 - Water injection pumps toggle

[Bloodhound 0]

Hello,

Is there a way to toggle the DC-6 water injection pumps using a button on the throttle? I can't find this function in the DC-6 Linda module, i tried with War Emergency Power in P3D but it doesn't seem to work.

Everything else works well, many thanks for the great Linda software and DC-6 module !

[guenseli 1,591]

Hello,

 

I haven't had the DC-6 installed for a while now ... and do not have that time currently.

So,out of my mind I have no solution, sorry

[Bloodhound 0]

Thanks for the answer. I don't use it all the time, so it's not that important. Maybe in the future you will have the time to look at it.

[dccraven 6]

From the manual:

13.3. w/a inJection system controlling switches — Each engine W/A injection system is controlled by two switches; the manual control switch on the aft overhead panel and an oil-pressure-operated switch, which tees off the oil pressure line supplying the engine oil pressure warning switch. The oil-pressure- operated switch, set to close when engine oil pressures exceed 25 (±5) psi, is connected in series with the on-off switch, thus preventing the W/A injection system pump from operating when the engines are not running. Turning the manual switch “ON “ with engines inoperative will not energize the W/A injection system.

Note that the injection will not occur just by turning the switches on, but takes the oil pressure to exceed 25 psi.