Hi,

I'm trying to install my new terminal for KCLT into FSX using the Instant Scenery 3. It's been a while since I've used it but my file is not showing up in the list. I've read the user's manual, and there are a lot of things that the manual does not explain well at all, and it is not in a logical order. It does not, and has never explained how to place objects created by someone. It only explains those that are default. It never goes into details about how and where to place those files created by someone to make them show up in the list. I'm tired of wasting my time reading over and over and over again and not getting a thing out of it. On page 8 under "Adding Objects," it says: To start adding new scenery objects, click on the Add Objects tab in the Instant Scenery Window. There is NO Add Objects tab in my IS3 Window. I assume when they say IS3 window, which they did not explain, I assume they mean the window that's opened from the Add On and Instant Scenery menu in FSX. If so, where's the Add Objects tab? Apparently, changes were made and the manual was never updated to reflect the changes, and I've seen this happened too many times. And googleling this topic does not bring any results either, other than the video that I did not find informative at all. It only explains things using default objects, NOT anything created. My question is how and where do I place this file into IS3 so that the file shows up in the list? This is not working and the manual does not explain any of this.

 

Ken.

Thw list is created by reading the scenery.cfg when IS3 is loaded.

 

37 minutes ago, GHD said:

Thw list is created by reading the scenery.cfg when IS3 is loaded.

 

Yes, but that does not explain my question. I need to know how I place my bgl in IS3, and where to place it. I placed the bgl in the Addon Scenery folder in a folder named KCLT New Terminal. In this folder are the sub-folders Scenery and Texture. If I go and add the scenery to the scenery library, that scenery object cannot be edited by IS3. So, I don't add it to the scenery library. But I'm supposed to be able to find it in the list and add that scenery object using IS3. Apparently, I'm not  placing the blg in the right location, and I need full details about how to do this, not just in a few words. 

Ken.